Back to Case studies

Case study · The record

What a hotel keeps on file for every one of 318 assets

Every asset on the guest floors, in the public areas and out front: specs, service history, and what we still need to find out.

Hampton Inn and Suites: Lobby Computer 2, its record, open in the 3D model Hampton Inn and Suites · Lobby Computer 2, its record
Video
Hampton Inn and Suites in 3D

Summary

Hampton Inn and Suites runs on BuiltOS.

Guest-room doors, public areas, the spa and the outside signs are all on the plan. Open any one from where it sits. Each asset shows its specs, service logs and history. It also lists what we don’t know yet.

  1. The sign out frontThe flicker, traced to the driver
  2. Door 412The closer, the hinge and the reader, each with a history
Read the article
Inside BuiltOS

Three views of this hotel.

  • Hampton Inn and Suites in BuiltOS: lobby record openThe record

    Navigating BuiltOS

    A walk through the same building in BuiltOS — every asset on the plan and what it carries.

  • Hampton Inn and Suites: Lobby Computer 2, its recordAn asset

    Asset page and its history

    Specs, service logs and the history timeline held on a single asset.

  • Hampton Inn and Suites: AC Unit, Room 502: what it has cost, and what comes nextCapEx

    Maintenance and CapEx

    Service intervals sitting on the asset, and the CapEx hub reading the same register.

Overview

Hampton Inn and Suites has 318 assets in BuiltOS. They include the guest floors and their door hardware, the public areas and the spa, the signs out front, and the equipment behind it all. Each one sits on the floor plan. You open it there, not from a spreadsheet.

An asset page is not a specification sheet. The specs are on it, and under them sit the service logs and a history timeline: what was done, when, and against which job it was raised. A guest room door reads as a sequence rather than a status — the closer tension adjusted, a hinge lubricated after a housekeeping squeak report, the peephole replaced, the card reader firmware updated. When a guest says the door slams and their key is sometimes refused, the complaint lands against that history instead of arriving on its own.

Hampton Inn and Suites: Room 502, asked why it is too hot again
Hampton Inn and Suites · Room 502, asked why it is too hot again

Every asset also carries a section for what we do not know about it. A serial nobody has read off a door closer, no install date on part of the exterior signage, no manual on file, a service interval nobody has confirmed. The gap is written down as a gap rather than left as an assumption, so the register is honest about its own coverage and the holes can be closed on the next visit rather than rediscovered on the next fault.

The copilot is per property. Asked why the sign on the front elevation is flickering, it answers out of this property’s register: when the lamp was last replaced, whether it is past its rated life, who installed the sign, and what has been raised against it before. The pattern of the flicker is the part worth knowing — it points at the driver rather than the lamp — so the work order is raised for the part that is actually failing, and it stays on the sign for whoever opens it next.

Hampton Inn and Suites: AC Unit, Room 502: what it has cost, and what comes next
Hampton Inn and Suites · AC Unit, Room 502: what it has cost, and what comes next

Maintenance runs off the same entries. Intervals live on the asset, so a door closer or a sign that has gone past its own interval is visible as itself and not as a line in a schedule kept somewhere else. CapEx planning is a separate hub reading the same register — the assets, their ages, their histories and the work already done to them — so the guest floors and the elevation over the entrance are planned for against what is recorded rather than against what is remembered.

Drawings Geometry Room Data Assets Warranties Records Transfer WORK ORDERS Dispatch Ownership Capital Drawings Geometry Room Data Assets Warranties Records Transfer WORK ORDERS Dispatch Ownership Capital
What it produces

One record for every asset, in 3D when it helps

  • The KFC restaurant in 3DMap

    Drawings and BIM become a measured 3D model

    KFC, from its own drawings. How we measure

  • Soda Machine 2 at Burger King, its record open in the 3D modelManage

    Every asset carries its own status and history

    Burger King’s Soda Machine 2, open where it stands.

  • Fuel Pump 4 at Shell: what it has cost, and the forecastImprove

    Price renovations from the 3D model

    Shell’s Fuel Pump 4: cost so far, and what to replace and when.